SCSpecial 100ml Large Plastic Syringe with 80cm (31.5in) Handy Plastic Tubing for Dispensing Injection

Had my car back after a service with warning light saying to reduce engine oil level. I tried this, as I didn't want to wait. The supplied tube had not been cut level on both ends. At first, I tried the skewed end but it wouldn't go down the dipstick pipe further than 10 cm. Measured how much is needed using the dipstick and tried the other level cut end. It went in with no issues. As soon as I started using the supplied syringe oil started to travel up the tube. The trick is to pull then let it breathe for a bit. The initial air pocket will decrease. Kept at it until full. Had to repeat the same process seven times and was able to get 700ml out which was enough to get the dipstick to the correct level. Washed it with some soapy warm water and stored it in case this happens again ( so not really single use). The tube attached ok to the syringe and as long as you use it for suction you won't face any issues.

You get what you pay for. It does the job. Took a bit of power to get the oil out. I ran it to get it a little warm so it comes out a bit better

Did the job well

As requested

pipe width and length is good but the product build quality is poor and it's labelled as single use only. It works in a pinch and with some patience.

Poor quality. Broke within minutes of using! Wasted £8 on a syringe that can’t even extract liquid properly. The syringe became extremely stiff to use and then cracked from the pressure. Waste of money, don’t bother.

This product did what I wanted it to do , such oil out of my transfer case. Can recommend.

Quality Product.